DES系列电源是专门为Magtrol的全系列涡流和粉末制动测力计设计的,其设计目标是提供最佳响应时间。DES系列产品包装在由铸铝制成的工业外壳中。这提供了优越的保护,以防止辐射排放,以避免任何周边电子模块的破坏。这个外壳必须直接安装在试验台上,紧挨着刹车,尽可能接近。DES系列电源可以通过来自外围电子设备的数字信号和模拟设定值来控制。DSP7000测功机控制器被设计用于DES系列。可通过远程控制开启电源。standby信号可以输出输出电流。励磁电流由0-10 V DC范围内的设定值控制。励磁电流的标称值是由内部电阻设定的。 There are two discrete outputs for alarms (open collector). The first is the “Temperature Alarm”. It will indicate if the cooling water of the Dynamometer or the inner temperature of the DES Series are out of limits. The second is the “Electrical Alarm”. It occurs when an over current or a short circuit is detected. The output current is immediately turned OFF and latched while the General Alarm Relay is set under its Alarm position. A low state for 200 ms of the Stand-by signal resets the latch. For applications with TANDEM dynanometers, the DES Series units also control the power supply of the electromagnetic clutch. The main supply voltage of the DES Series is in the 115/230 VAC – 50/60 Hz range.