带锯BS 712牛

对金属 电

切割元件可手动或由任何送料装置送料。切削时的进给量是根据双腔液压缸中油液流动的原理而产生的。通过改变蜗轮与驱动电机之间的皮带轮的传动比，得到所需的带线速度。通过阀控制液压缸腔间的油流量，获得了合适的降臂速度。臂部采用异形球墨铸铁，坚固耐用，能吸收各种振动。靠近蜗轮一个控制面板是位于。切割带动力传动系统由两个铸铁车轮组成。第一轮是张紧轮(用杠杆调节)，第二轮是驱动轮。张紧轮直接由蜗轮传递转矩，而蜗轮由电动机驱动。通过一组轴承滚子给出合适的带倾角。 The base of the machine is a rigid cuboid made of steel sheets inside which is a cooling fluid container with a flood coolant pump. Thanks to a swivel vice it is possible to cut material at angles of 0 – 45o. To the upper part of the machine base a tank is fixed for flood coolant draining and a container for chips produced during material cutting. On the tank a cast iron work table is installed on which is the vice clamping material and to which the band-saw arm is fixed. In the lower part of the machine pedestal are holes for wheel axles. Safety during cutting process is secured by an electric installation meeting all CE requirements.