洛氏硬度试验机DIGIROCK-RSR

台式 为有色金属 铝

技术参数预载(kgf):3 / 10试验载荷(kgf):15、30、45、60、100、150载荷选择:通过载荷选择盘试验方法:罗克韦尔、罗克韦尔表面载荷应用:液压最大。测试高度:280毫米深喉咙:145毫米机昏暗的:720 x520x280毫米案例昏暗的:440 x590x950毫米重量(net/gross): 82/110公斤Standart配件罗克韦尔钻石Identor: 1 1/16“球压痕器:1 HRC测试块:1 HRB测试块:1平测试表:1 V测试表:1硬度换算表:1例附件:1封面:1艾伦扳手:2橡胶Bellow for Elevating Screw:1 Instruction Manual:1 Calibration Certificate:1 Unpacking of equipment Unscrew fixing steel sheet plates of upper side to wooden base of case and hold up upper side of wooden case by means of carrying handles. Take out two M8 bolts fastening equipment to lower wooden case. Locate equipment on a special table (see drawing of table enclosed) and fasten two M8 bolts by means of eye bull putting on flat testing table. Open left cover. Take out wooden safety parts. Take out also 3 off M6 bolts of top cover by means of 5 mm special alyen key which is in accessory box with care. Take out plastic safety parts. Equipment is now ready for testing. Setting into operation Before starting to test, load aplication lever (KL2) has to be in starting position (see drawing). Locate part to be tested on testing table, Insert indentor to holder (ML3) and choose load by means of load selector disc (VL1) (according to testing method in attached table).